3-Step Installation Tips

3-Step Installation Tips


 

Step 1 - Configuration and Bench Test

  1. Lay out all devices on a table.
  2. Read the instruction manuals and connect each device.
  3. Double-check all connections before powering up.
  4. Configure the devices and enable the required features.
  5. Bench-test every configured feature to ensure proper operation.

Tip:

  • For wireless devices, temporarily position them where they will be installed and test for signal strength. Avoid unnecessary physical barriers.
  • For hardwired devices, estimate your cable length requirements and test using a cable at least a few meters longer than your estimate.

Step 2 - Cabling, Mounting & Termination

This stage is straightforward for wireless devices but more complex for hardwired installations. Above all, prioritise safety whether you are installing yourself or hiring professionals. Always ensure professionals are licensed and insured.

Best Practices:

  • Avoid installing devices near sources of interference. For wireless devices, minimise physical obstructions between transmitters and receivers—especially metal barriers or steel sheds.
  • Do not share conduits or holes with electrical cables.
  • Keep a safe separation:
  • ≥150mm from 240V lines
  • ≥350mm from 415V lines
  • When crossing electrical cables, use a fixed, non-conductive barrier.
  • Take care when accessing ceiling spaces or crawl areas—watch for heat, confined spaces, and possible live wires.
  • Before drilling, check for hidden electrical wiring, gas pipes, or water pipes.
  • Use ladders safely and assess fall risks before working at height.
  • Power off all devices before termination.
  • Never touch circuit components with bare fingers.
  • HDMI cables are fragile - avoid bending or stressing connectors. For long or difficult runs, consider Cat6 cable with HDMI-over-Cat6 converters.

Step 3 - Walk Testing

After installation, perform a walk test:

  • Check that each device responds correctly.
  • Adjust sensor positions, camera angles, and device settings as needed.
  • Confirm that all configured features function reliably.